Kenworth Coloum switch suits T-401

NOTE: Some Model Kenworth Trucks use a different larger diameter Steering
Column (around 48.0mm). The 32-996 suits a 40.0mm diameter column so the aluminium housing on BOTH sides of the switch will need to be ground down using a Die Grinder or similar to install it. Approximately 4.5mm needs to be ground off each of the 2 surfaces (mark with a black vivid marker before grinding). The old switch clamp piece can be reused for the correct size matching half.
NOTE: ENSURE ALL APPETURES FOR THE INDICATOR SELF CANCELLING ETC IN
THE SWITCH BODY ARE COVERED WITH TAPE BEFORE
GRINDING TAKES PLACE TO
ENSURE SWARF IS NOT INGESTED INTO THE SWITCH.
NO WARRANTY ON SWITCH FAILURES DUE TO SWARF INGRESS !!
Functions:
Wiper (4 position - turn)
Washer (slide)
Headlamp Dip (Pull)
Horn (Button push on end)
Plugs:
White (Male) - 8 Pole - 8 wires used
White (Female) - 6 Pole - 6 wires used